Passed Exam Today 300-615

Page: 5 / 6

Question 20

A network engineer finds an error that says, "BIOS failed power-on self-test." When the engineer checks the console, they discover that the Cisco UCS Blade firmware upgrade process stopped at the "Configuring and testing memory" stage.

Which set of actions resolves the issue?

Options:

1. Add the CIMC firmware on a server.

2. Initialize the CIMC firmware on a server.

1. Update the BIOS firmware on a server.

2. Activate the BIOS firmware on a server

1. Create a new host firmware package.

2. Assign the host firmware package to the service profile template.

1. Upgrade the firmware on an adapter.

2. Enable the firmware on an adapter.

Question 21

Refer to the exhibit.

A recent configuration change removes the HSRP adjacency between the SW-1 and SW-2 Cisco Nexus switches. The change causes the servers on this subnet to lose Internet access. Which action restores the connectivity of all servers on VLAN 13?

Options:

Disable HSRP IP redirects on SW-1.

Set the HSRP priority to 70 on SW-1.

Activate HSRP preempt on SW-2.

Set the HSRP password on SW-2.

Question 22

Refer to the exhibit. A network engineer must use BGP to route IPv4 and IPv6 routes between R1 and R2. The IPv4 addresses are exchanged as expected between the routers through BGP. The routers have reached an Established BGP state. However, the IPv6 routes from R2 fail to show in the routing table of R1. Which action resolves the issue?

Options:

Create a route map that sets the IPv6 next hop.

Advertise L2VPN EVPN under IPv4 unicast address family

Configure an IPv6 BGP neighbor on R1

Enable IPv6 routing on R1

Question 23

Refer to the exhibit.

A switch is being downgraded to an earlier release because of a problem with the current release. After the switch is downgraded, it can no longer forward traffic. Which action resolves the issue?