A network engineer must segregate all IPads on the guest WLAN to a separate VLAN. How does the engineer accomplish this task without using Cisco
ISE?
An engineer is setting up a new unique NAD on a Cisco ISE.
Which two parameters must be configured? (Choose two.)
An engineer must implement Cisco Identity-Based Networking Services at a remote site using ISE to dynamically assign groups of users to specific IP subnets. If the subnet assigned to a client is available at the remote site, then traffic must be offloaded locally, and subnets are unavailable at the remote site must be tunneled back to the WLC. Which feature meets these requirements?
A customer must provide remote users with secure wireless access through a Cisco Catalyst 9800 Series Wireless Controller and Cisco APs. The corporate WLAN must be extended over the Internet to specific locations and support a locally installed IP phone.
Which two actions accomplish this configuration? (Choose two.)
A wireless network uses Cisco ISE to implement 802 1x for user authentication and an Active Directory server as a user database After a power outage, the wireless clients cannot connect to the wireless network The ISE log reports a "clock skew" Which action addresses this issue?
All APs are receiving multicast traffic, instead of only the APs that need it. What is the cause of this problem?
A customer configures iPSK for use with a Cisco Catalyst 9800 Series controller. The configuration is complete, but the wireless client fails to authenticate to the network. Which implementation resolves this issue?
Refer to the exhibit.
A wireless engineer has integrated the wireless network with a RADIUS server. Although the configuration on the RADIUS is correct, users are reporting that they are unable to connect. During troubleshooting, the engineer notices that the authentication requests are being dropped. Which action will resolve the issue?

A corporation has a wireless network in which all APs are configured in FlexConnect mode. The WLC has a data WLAN and a VoWiFi WLAN, and both SSIDs are centrally switched. Which QoS configuration must be implemented so that wireless packets maintain their markings across the wired and wireless networks?
An engineer manages a Cisco Catalyst 9800 WLC with 500 APs connected. After enabling multicast, the controller experiences a spike in CPU overhead and overall network utilization. The engineer must configure the WLC so that multicast traffic is delivered efficiently to all APs without overloading the controller. Which feature should the engineer enable to implement this solution?