An engineer configures an application-aware routing policy for a group of sites The locations depend on public and private transports The policy does not work as expected when one of the transports does not perform properly This policy is configured:
which configuration completes the policy so that it works for all locations?
A)
B)
C)
D)
An engineer must configure VRRP for redundancy on WAN Edge router1 running an earlier version than 20.6, considering WAN Edge router2 is configured correctly. Which configuration meets the requirement?
Refer to the exhibit. An engineer must configure the Overlay Management Protocol route preference so that when B2 tries to reach host routes advertised by B1 it always chooses the MPLS circuit. Which two match conditions must be configured to accomplish this task? (Choose two.)
Refer to the exhibit.
An enterprise has hub and spoke topology where it has several VPNs. An engineer must allow users in VPN91 to reach users in VPN92 and VPN10 to reach VPN91 and VPN92. Which configuration meets these requirements?
What is the default value (in milliseconds) set tor the poll interval in the BFD basic configuration?
A network administrator is tasked to make sure that an OMP peer session is closed after missing three consecutive keepalive messages in 3 minutes. Additionally, route updates must be sent every minute. If a WAN Edge router becomes unavailable, the peer must use last known information to forward packets for 12 hours. Which set of configuration commands accomplishes this task?
A network administrator is configuring a tunnel interface on a branch Cisco IOS XE router to run TLOC extensions. Which configuration will extend a TLOC over a GRE tunnel to another router in the branch?
What do receivers request to join multicast streams in a Cisco SO-WAN network?
Refer to the exhibit.
An engineer configured OMP with an overlay-as of 10666. What is the AS-PATH for prefix 104.104.104.104/32 on R100?
TESTED 29 Oct 2025
