D-ISM-FN-01 Exam Dumps - EMC DCA-ISM Questions and Answers

Capacity planning reports in storage environments focus on:

Utilization trendsof storage systems (e.g., used vs. available space)

File system usage(volumes, file systems)

Ports (SAN/NAS connections)

This enables proactive capacity management and ensures enough resources are available to meet future demands.

Data Center Bridging (DCB)is a set of IEEE standards designed to enhance Ethernet for converged data center networks.

DCB includespriority-based flow control (PFC)toreduce frame lossduring congestion.

Ensureslossless Ethernet transport, crucial for storage traffic (like FCoE).

QoS (A)prioritizes traffic but doesn’t guarantee lossless transport.

NAT (C)translates IP addresses, not relevant to lossless transport.

VLAN (D)segments networks logically but doesn’t address congestion.

Dell RecoverPoint is a continuous data protection (CDP) solution that uses journaling to provideany point-in-time recoveryof data. It continuously captures and replicates data changes, storing them in a journal to enable precise recovery to any required point in the past.

Dell SRDF (Symmetrix Remote Data Facility):Provides synchronous/asynchronous replication, not CDP.

Dell TimeFinder SnapVX:Creates point-in-time snapshots but doesn’t offer continuous journaling.

Dell Cloud Tier:Used for archiving older data to the cloud.

To calculate the MTBF, we need to determine the total operational time and the number of failures.

Total operational time (Monday to Friday):5 days × 24 hours = 120 hours

Number of failures:3 (Tuesday, Thursday, Friday)

MTBF = Total operational time / Number of failures

MTBF = 120 hours / 3 = 40 hours

Cloud-based backupsolutions are managed by third-party providers and offer easy scalability, flexibility, and reduced IT management overhead. They allow businesses to focus on operations while the provider manages infrastructure, updates, and capacity.

Image-based backup:Captures entire system images but may still require local storage and management.

Agent-based backup:Deploys agents to servers, requiring management of the agents.

Tape-based backup:Involves hardware and manual processes for storage, increasing management burden.

Data deduplication is a technique that eliminates redundant copies of data, storing only unique instances. When multiple copies of the same data are found, deduplication replaces them with references to a single stored copy, significantly reducing storage requirements.

Data replication:Involves copying data to another location for redundancy, not reducing storage size.

Data encryption:Secures data but doesn't affect storage size.

Data compression:Reduces data size by encoding information more efficiently but doesn't eliminate duplicates.

Using SSDs as asecondary cache(sometimes called a “flash cache”) helps:

Improve read performanceby storing frequently accessed data in the faster SSDs.

Reduce latency for read requests because SSDs are much faster than traditional spinning hard drives (HDDs).

Power consumption (A): SSDs do use less power, but the primary goal here is performance.

Data backup (C): SSD cache doesn’t impact backup operations.

Storage capacity (D): This is not the main focus; the SSDs act as a cache layer only.

Storage Class Memory (SCM) represents a new class of storage technology that bridges the gap between traditional DRAM and NAND flash memory. SCM offers significantly lower latency and higher endurance compared to NAND flash, making it the highest-performing storage medium currently available. Due to its advanced technology and performance characteristics, SCM is also the most expensive among the listed options.

FC (Fibre Channel):A network protocol used for high-speed data transfer, not a type of disk device.

SATA (Serial ATA):Commonly used in consumer-grade storage; offers lower performance and cost.

SAS (Serial Attached SCSI):Offers better performance than SATA but still lags behind SSDs and SCM.

SSD (Solid State Drive):Provides faster data access than HDDs but is outperformed by SCM.

SCM (Storage Class Memory):Combines the speed of DRAM with the persistence of NAND, offering unparalleled performance.