H31-341_V2.5 Exam Dumps - Huawei HCIP Transmission Questions and Answers

The OTUk_LOM (Loss of Multiframe) alarm indicates a framing alignment issue and is generated when the Out Of Multiframe (OOM) state persists for at least 3 milliseconds. This rapid alarm triggering helps detect synchronization failures quickly, allowing prompt response to maintain network stability. HCIP-Transmission details this alarm behavior within OTN frame monitoring functions, highlighting the critical role of frame alignment in maintaining signal integrity across optical networks.

With an initial RI1–RI2 difference of 2 dB and a 5 dB threshold, only when the active channel’s loss increases by 7 dB (to 3 dBm) while the standby remains at 8 dBm does the difference reach 5 dB and trigger switching.

To prevent non-linear effects within dispersion compensation modules, the single-wavelength input power must not exceed –4 dBm.

When a GE (Gigabit Ethernet) service is encapsulated into an OTN frame or an SDH frame structure, the client-side alarms reported are not different; they are consistent regardless of the encapsulation method. This consistency ensures reliable fault detection and service monitoring across different transport technologies. HCIP-Transmission specifies that client alarms depend on service and interface definitions rather than the underlying framing, ensuring seamless interoperability and troubleshooting in multi-protocol environments.

The EDFA (Erbium-Doped Fiber Amplifier) amplifies optical signals but also introduces Amplified Spontaneous Emission (ASE) noise, making it the primary noise source in optical transmission systems.

ESC (Enhanced Supervision Channel) uses Fixed frame structure DCC and Embedded DCC types to transmit supervisory and management information within the optical channel.

In 1+1 optical line protection configurations, either the RI1/TO1 path or the RI2/TO2 path can be designated as the working channel.

The OptiXtrans DC908 chassis supports both DC and AC power supply configurations, allowing it to operate as either a DC chassis or an AC chassis.

In Link Aggregation Group (LAG) settings, port priority determines which ports carry traffic preferentially. (A) If a primary port is configured to preferentially carry services, it must have a higher priority than other ports to ensure it is selected first. Port priority is numerically represented, and (D) a lower value of “port priority” means higher priority, which can be counterintuitive but is standard in networking. For manual aggregation groups that don’t run LACP, priority settings typically do not apply. This priority mechanism helps optimize link utilization and failover in aggregated links, as detailed in HCIP-Transmission documentation on Ethernet and service aggregation.

The electrical-layer structure of OTN frames follows the path: OTUk → ODUk → OPUk → Client. OTUk is the outer frame layer that carries ODUk (Optical Data Unit), which in turn contains OPUk (Optical Payload Unit). The OPUk holds the client signal payload. This hierarchical encapsulation supports transparent transport of client signals over optical networks. Understanding this sequence is essential for managing signal mapping and monitoring in OTN networks as outlined in HCIP-Transmission documentation.