200-301 Exam Dumps - Cisco CCNA Questions and Answers

Which Rapid PVST+ feature should be configured on a switch port to immediately send traffic to a connected server as soon as it is active?

Which alternative to password authentication Is Implemented to allow enterprise devices to log in to the corporate network?

Which type of encryption does WPA1 use for data protection?

What is a DHCP client?

Which plane is centralized in software-defined networking?

Refer to the exhibit.

How many JSON objects are represented?

What is a feature of WPA?

Refer to the exhibit. A network administrator configures the CPE to provide internet access to the company headquarters. Traffic must be load-balanced via ISP1 and ISP2 to ensure redundancy. Which two command sets must be configured on the CPE router? (Choose two.)

A Cisco engineer at a new branch office is configuring a wireless network with access points that connect to a controller that is based at corporate headquarters Wireless client traffic must terminate at the branch office and access-point survivability is required in the event of a WAN outage Which access point mode must be selected?

A router received three destination prefixes:10.0.0/18, and 10.0.0/24. When the show ip route command is executed, which output does it return?

A)

B)

C)

D)

Why implement VRRP?

Refer to the exhibit. An engineer just installed network 10.120.10.0/24. Which configuration must be applied to the R14 router to add the new network to its OSPF routing table?

A wireless access point is needed and must meet these requirements:

• "zero-touch" deployed and managed by a WLC

• process only real-time MAC functionality

• used in a split-MAC architecture. Which access point type must be used?

Refer to the exhibit.

What does route 10.0.1.3/32 represent in the routing table?

Refer to the exhibit.

A)

B)

C)

D)

Which mechanism carries multicast traffic between remote sites and supports encryption?

The address block 192.168.32.0/24 must be subnetted into smaller networks. The engineer must meet these requirements:

Create 8 new subnets

Each subnet must accommodate 30 hosts

Interface VLAN 10 must use the last usable IP in the first new subnet.

A Layer 3 interface is used.

Which configuration must be applied to the interface?

Refer to the exhibit. A packet sourced from 172.16.32.254 is destined for 172.16.32.8. What is the subnet mask of the preferred destination route?

What are two characteristics of a controller-based network? (Choose two.)

SIP-based Call Admission Control must be configured in the Cisco WLC GUI. SIP call-snooping ports are configured. Which two actions must be completed next? (Choose two.)