The Cisco Wireless LAN Controller and guest portal must be set up in Cisco ISE. These configurations were performed:
• configured all the required Cisco Wireless LAN Controller configurations
• added the wireless controller to Cisco ISE network devices
• created an endpoint identity group
• configured credentials to be sent by email
• configured the SMTP server
• configured an authorization profile with redirection to the guest portal and redirected the access control list
• configured an authentication policy for MAB users
• created an authorization policy
Which two components would be required to complete the configuration? (Choose two.)
An engineer is unable to use SSH to connect to a switch after adding the required CLI commands to the device to enable TACACS+. The device administration license has been added to Cisco ISE, and the required policies have been created. Which action is needed to enable access to the switch?
An administrator is configuring a new profiling policy in Cisco ISE for a printer type that is missing from the profiler feed The logical profile Printers must be used in the authorization rule and the rule must be hit. What must be done to ensure that this configuration will be successful^
A network engineer has been tasked with enabling a switch to support standard web authentication for Cisco ISE. This must include the ability to provision for URL redirection on authentication Which two commands must be entered to meet this requirement? (Choose two)
A user reports that the RADIUS accounting packets are not being seen on the Cisco ISE server.
Which command is the user missing in the switch’s configuration?
A network security engineer needs to configure 802.1X port authentication to allow a single host to be authenticated for data and another single host to be authenticated for voice. Which command should the engineer run on the interface to accomplish this goal?
TESTED 28 Jul 2026
