When planning for the deployment of Cisco ISE, an organization's security policy dictates that they must use network access authentication via RADIUS. It also states that the deployment provide an adequate amount of security and visibility for the hosts on the network. Why should the engineer configure MAB in this situation?
What must be configured on the Cisco ISE authentication policy for unknown MAC addresses/identities for successful authentication?
An administrator is configuring posture assessment in Cisco ISE for the first time. Which two components must be uploaded to Cisco ISE to use Anyconnect for the agent configuration in a client provisioning policy? (Choose two.)
An engineer is configuring Cisco ISE policies to support MAB for devices that do not have 802.1X capabilities. The engineer is configuring new endpoint identity groups as conditions to be used in the AuthZ policies, but noticed that the endpoints are not hitting the correct policies. What must be done in order to get the devices into the right policies?
A network engineer must create a guest portal for wireless guests on Cisco ISE. The guest users must not be able to create accounts; however, the portal should require a username and password to connect. Which portal type must be created in Cisco ISE to meet the requirements?
The Cisco Wireless LAN Controller and guest portal must be set up in Cisco ISE. These configurations were performed:
• configured all the required Cisco Wireless LAN Controller configurations
• added the wireless controller to Cisco ISE network devices
• created an endpoint identity group
• configured credentials to be sent by email
• configured the SMTP server
• configured an authorization profile with redirection to the guest portal and redirected the access control list
• configured an authentication policy for MAB users
• created an authorization policy
Which two components would be required to complete the configuration? (Choose two.)
An administrator is configuring sponsored guest access using Cisco ISE Access must be restricted to the sponsor portal to ensure that only necessary employees can issue sponsored accounts and employees must be classified to do so What must be done to accomplish this task?
An administrator is configuring a new profiling policy within Cisco ISE The organization has several endpoints that are the same device type and all have the same Block ID in their MAC address. The profiler does not currently have a profiling policy created to categorize these endpoints. therefore a custom profiling policy must be created Which condition must the administrator use in order to properly profile an ACME Al Connector endpoint for network access with MAC address
TESTED 17 Dec 2025
