An engineer configures local roule group names to simplify a dial plan. Where does the engineer set the route groups according to the local route group names that are configured?
Which two steps should be taken to provision a phone after the Self-Provisioning feature was configured for end users? (Choose two.)
Which two conditions must a user meet to provision a new device using the self-provisioning feature? (Choose two.)
Exhibit.
Refer the exhibit. A collaboration engineer needs to replace the original, single NTP
server that was configured during the inital install of a Cisco UCM server. What is the first
step to accomplish this task?
Which value should be changed when each Cisco UCM node does not allow for more than 5000 phones to be registered?
An administrator is configuring a new Cisco UCM with PSTN capabilities. Due to
bandwidth constraints, audio compression is used on the codec. DTMF must work as
expected because the customer is calling many call centers where the users must select
options in the call. Where is DTMF out-of-band in a CCM 12.5 with SIP-based gateway
configured?
Which two parameters influence the total number of supported conference participants on a Cisco IOS XE router that has DSP modules? (Choose two.)
What are two functions of Cisco Expressway in the Collaboration Edge? (Choose two.)
A SIP phone has been configured in the system with MAC address 0030.96D2.D5CB. The phone retrieves the configuration file from the Cisco UCM. Which naming format is the file that is downloaded?
An engineer implements a new Cisco UCM based telephony system per these requirements.
•The local Ethernet bandwidth is sized based on the total bandwidth per call
•A G 736 codec is used.
•The bit rate is 64 kbps
•The codec sample interval is 10 ms
•The voice payload size is 160 bytes per 20 ms
What should the size of the Ethernet bandwidth be per call?
TESTED 29 Jan 2026
