ANVE Exam Dumps - Axis Communications Certifications Questions and Answers

The f-stop value of a lens will get higher if you zoom in. This is true because as the focal length increases (when zooming in), the lens aperture typically becomes smaller, resulting in a higher f-stop value. This change affects the amount of light entering the camera, which is an important consideration for PTZ (Pan-Tilt-Zoom) cameras when they are used in varying lighting conditions.

In a switched network with Unicast, data packets are sent from the source to a single specific recipient. No other computers on the network will receive the data intended for that recipient. This method ensures that the communication is direct and private between the sender and the receiver, which helps in managing network bandwidth efficiently. [Reference: Axis Communications - Networking Basics for IP Surveillance]

A VPN (Virtual Private Network) creates a secure tunnel through the network where your information travels encrypted. This means that data transmitted over the VPN is protected from eavesdropping and unauthorized access. It is not specifically optimized for video data packets nor does it translate domain names to IP addresses. Therefore, the correct answer is C. For more detailed information, refer to Axis Communications' guidelines on secure remote access and VPN usage.

The maximum distance for a 100BaseTX Ethernet carrying 802.3at PoE connection between a switch and a camera without any extenders or repeaters is 100 meters (328 feet). This standard distance is applicable for most Ethernet networks and ensures reliable power and data transmission over the specified length.

When using the AXIS Design Tool, it is crucial to convey to the end user that the calculations provided are only estimates and not final numbers. The tool is designed to offer a rough estimate of network bandwidth and storage needs based on various factors such as camera resolution, frame rate, and compression. However, real-world conditions and specific system configurations can affect these calculations, so they should be treated as approximations rather than exact figures.

Image flickering is often caused by fluorescent lights due to their characteristic rapid on-off cycling. This cycling can interfere with the camera's frame rate, leading to visible flicker in the captured video. Adjusting the camera settings to match the frequency of the fluorescent lights can help reduce this effect. For more information, consult Axis Communications' troubleshooting guides on image flickering.

When connecting and powering a PIR sensor from an Axis camera's I/O port, the output DC voltage provided is 3.3 V. This is a standard output voltage for many Axis network cameras, which allows integration of various low-power devices and sensors directly with the camera’s I/O ports.

Focusing a camera with an auto iris is more accurate when set during lowlight conditions. In low light, the iris opens wider, resulting in a shorter depth of field. This forces the focus to be more precise within that narrower range, ensuring that the focus is set correctly. When lighting conditions improve and the iris closes down, the depth of field increases, maintaining a broader range of focus.

Image flickering on an AXIS P1344 can often be attributed to the camera's exposure settings. Flickering is usually caused by lighting conditions that fluctuate at a frequency different from the camera's current exposure settings, leading to the perception of flicker. Adjusting the exposure settings can synchronize the camera with the lighting conditions, thus reducing or eliminating the flickering issue. This can be done by accessing the camera’s web interface and navigating to the image settings to adjust the exposure mode or exposure value. According to Axis Communications' product documentation, fine-tuning the exposure settings is a recommended step to mitigate flickering.