Weekend Special Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: bigdisc65

FCSS_NST_SE-7.4 Exam Dumps - Fortinet Certified Solution Specialist Questions and Answers

Question # 4

Refer to the exhibit, which shows a truncated output of a real-time LDAP debug.

What two conclusions can you draw from the output? (Choose two.)

Options:

A.

The name of the configured LDAP server is Lab.

B.

The user is authenticating using CN=John Smith.

C.

FortiOS is able to locate the user in step 3 (Bind Request) of the LDAP authentication process.

D.

FortiOS is performing the second step (Search Request) in the LDAP authentication process.

Buy Now
Question # 5

In IKEv2, which exchange establishes the first CHILD_SA?

Options:

A.

IKE_SA_INIT

B.

INFORMATIONAL

C.

CREATE_CHILD_SA

D.

IKE_Auth

Buy Now
Question # 6

Exhibit.

Refer to the exhibit, which shows the output of get system ha status.

NGFW-1 and NGFW-2 have been up for a week.

Which two statements about the output are true? (Choose two.)

Options:

A.

If a configuration change is made to the primary FortiGate at this time, the secondary will initiate a synchronization reset.

B.

If port 7 becomes disconnected on the secondary, both FortiGate devices will elect itself as primary.

C.

If FGVM...649 is rebooted. FGVM...650 will become the primary and retain that role, even after FGVM...649 rejoins the cluster.

D.

If no action is taken, the primary FortiGate will leave the cluster because of the current sync status.

Buy Now
Question # 7

During which phase of IKEv2 does the Diffie-Helman key exchange take place?

Options:

A.

IKE_Req_INIT

B.

Create_CHILD_SA

C.

IKE_Auth

D.

IKE_SA_INIT

Buy Now
Question # 8

Exhibit.

Refer to the exhibit, which contains a screenshot of some phase 1 settings.

The VPN is not up. To diagnose the issue, the administrator enters the following CLI commands on an SSH session on FortiGate:

However, the IKE real-time debug does not show any output. Why?

Options:

A.

The administrator must also run the command diagnose debug enable.

B.

The debug shows only error messages. If there is no output, then the phase 1 and phase 2 configurations match.

C.

The log-filter setting is incorrect. The VPN traffic does not match this filter.

D.

Replace diagnose debug application ike -1 with diagnose debug application ipsec -1.

Buy Now
Question # 9

Refer to the exhibit, which shows the partial output of a diagnose command.

Which two conclusions can you draw from the output shown in the exhibit? (Choose two.)

Options:

A.

FortiGate will drop the expected traffic if it does not arrive within 23 seconds.

B.

Clearing the master session has no impact on the expectation session.

C.

This is a pinhole session to allow traffic for a TCP protocol that dynamically assigns TCP ports.

D.

The session is checked against firewall policy ID 25.

Buy Now
Question # 10

In which two slates is a given session categorized as ephemeral? (Choose two.)

Options:

A.

A UDP session with only one packet received

B.

A UOP session with packets sent and received

C.

A TCP session waiting for the SYN ACK

D.

A TCP session waiting for FIN ACK

Buy Now
Question # 11

Refer to the exhibit, which contains the output of diagnose vpn tunnel list.

Which command will capture ESP traffic for the VPN named DialUp_0?

Options:

A.

diagnose sniffer packet any 'ip proto 50'

B.

diagnose sniffer packet any 'host 10.0.10.10'

C.

diagnose sniffer packet any 'esp and host 10.200.3.2'

D.

diagnose sniffer packet any 'port 4500'

Buy Now
Question # 12

Refer to the exhibit.

Assuming a default configuration, which three statements are true? (Choose three.)

Options:

A.

Strict RPF is enabled by default.

B.

User B: Fail. There is no route to 95.56.234.24 using wan2 in the routing table.

C.

User A: Pass. The default static route through wan1 passes the RPF check regardless of the source IP address.

D.

User B: Pass. FortiGate will use asymmetric routing using wan1 to reply to traffic for 95.56.234.24.

E.

User C: Fail. There is no route to 10.0.4.63 using port1 in the touting table.

Buy Now
Question # 13

Refer to the exhibits.

An administrator Is expecting to receive advertised route 8.8.8.8/32 from FGT-A. On FGT-B, they confirm that the route is being advertised and received, however, the route is not being injected into the routing table. What is the most likely cause of this issue?

Options:

A.

A batter route to the 8.8.8.8/32 network exists in the routing table.

B.

FGT-B is configured with a prefix list denying the 8.8.8.8/32 network to be injected into the routing table.

C.

The administrator has misconfigured redistribution of routes on FGT-A.

D.

FGT-8 is configured with a distribution list denying the 8.8.8.8/32 network to be injected into the routing table.

Buy Now
Exam Code: FCSS_NST_SE-7.4
Exam Name: FCSS - Network Security 7.4 Support Engineer
Last Update: Jun 15, 2025
Questions: 66
FCSS_NST_SE-7.4 pdf

FCSS_NST_SE-7.4 PDF

$29.75  $84.99
FCSS_NST_SE-7.4 Engine

FCSS_NST_SE-7.4 Testing Engine

$33.25  $94.99
FCSS_NST_SE-7.4 PDF + Engine

FCSS_NST_SE-7.4 PDF + Testing Engine

$47.25  $134.99