Black Friday Mega Drop - Up to 75% Off Best Sellers - Ends in 0d 00h 00m 00s - Coupon code: certbig75

H12-831_V1.0 Exam Dumps - Huawei HCIP-Datacom Questions and Answers

Question # 54

When a fault occurs on an OSPF network, traffic can be switched to another path only after several phases. Sort these phases in the correct sequence.

Options:

Buy Now
Question # 55

On the OSPF network shown in the figure, area 1 is a stub area, area 2 is a totally stub area, and area 3 is an NSSA. By default, which of the following routers does not have default routes in its routing table?

Options:

A.

R3

B.

R6

C.

R4

D.

R5

Buy Now
Question # 56

A network engineer provides a troubleshooting report after rectifying a fault. The actual network is simplified into the one shown in the figure, where:

    R1 and R2 both have OSPF enabled.

    R1 and R2 function as the gateways for PC1 and PC2, respectively.

Given this, which of the following statements are true?

Options:

Options:

A.

R1 can ping 192.168.1.22.

B.

R1 can ping 192.168.1.21.

C.

R2 can ping 192.168.1.2.

D.

PC1 and PC2 cannot ping each other.

Buy Now
Question # 57

VLAN aggregation uses multiple sub-VLANs to isolate broadcast domains on a physical network and aggregates these sub-VLANs into a logical super-VLAN. Which of the following statements is true about VLAN aggregation?

Options:

A.

If a super-VLAN and the corresponding VLANIF interface are created on a core switch, the VLANIF interface goes Up as long as there is a physical interface in Up state on the core switch.

B.

When configuring VLAN aggregation, you can configure VLAN 1 as a super-VLAN.

C.

If different sub-VLANs belong to the same super-VLAN, hosts in these sub-VLANs can directly communicate at Layer 2.

D.

If proxy ARP is enabled on the VLANIF interface corresponding to a super-VLAN, ARP entries can be generated to allow all sub-VLANs to communicate.

Buy Now
Question # 58

If the migration preparation is insufficient, which of the following problems may occur?

Options (Multiple Choice):

Options:

A.

When an interface cannot go up but no network cable tester is available, it is difficult to determine whether the interface hardware or cable is faulty.

B.

The migration fails, and the configuration file is not backed up. As a result, the service rollback fails.

C.

A hardware fault occurs on a board, but no spare board is available.

D.

Engineers cannot arrive at the migration site at the scheduled time.

Buy Now
Question # 59

On the network shown in the figure, IS-IS IPv6 runs on R2, R6, and R3, and the IPv6 address of Loopback0 on R6 is 2000::6/128. OSPFv3 runs on other links. Area 1 is a stub area, and Area 2 is an NSSA. IS-IS routes are imported to OSPFv3 on R2 and R3. Which of the following statements are false?

Options:

A.

R3 generates an Inter-Area-Router-LSA in area 0.

B.

R2 generates an Inter-Area-Router-LSA in area 0.

C.

R1 generates an Inter-Area-Router-LSA in area 2.

D.

R2 generates an Inter-Area-Router-LSA in area 1.

Buy Now
Question # 60

In the hub-spoke networking shown in the figure, which of the following commands must be configured on the Hub-PE to ensure correct route transmission?

Options:

A.

[Hub-PE-bgp-VPN_out] peer x.x.x.x allow-as-loop

B.

[Hub-PE-bgp-VPN_in] peer x.x.x.x allow-as-loop

C.

[Hub-PE-bgp-VPN_in] peer x.x.x.x soo 200:1

D.

[Hub-PE-bgp-VPN_out] peer x.x.x.x soo 200:1

Buy Now
Question # 61

R1 forwards a packet with the destination IP address of 4.4.4.4 on an MPLS network.

    Some LSP (Label Switched Path) information of R3 is shown in the figure.

    During packet transmission, which of the following devices perform MPLS label operations?

Options:

A.

R4

B.

R2

C.

R1

D.

R3

Buy Now
Question # 62

On an enterprise network shown in the figure, EBGP is deployed between CEs and PEs.

CE1 sends a VPN route to PE1.

Which of the following statements are false?

Options:

Options:

A.

To enable CE3 to receive the route, run the command peer 10.1.1.1 soo 200:1 on PE1.

B.

If the commands peer 10.1.1.1 soo 200:1 and peer 10.1.2.1 soo 200:1 are run on PE1, CE2 accepts the route.

C.

If the command peer 10.1.3.1 substitute-as is run on PE2, CE3 accepts the route.

D.

If no additional action is taken, CE3 discards the route.

Buy Now
Question # 63

An administrator runs the display mpls lsp command to view LSPs on a device. The command output is shown in the figure.

Which of the following statements is true?

Options:

Options:

A.

Before forwarding a packet destined for 2.2.2.2, the device adds label 3 to the packet.

B.

Before forwarding a packet destined for 1.1.1.1, the device adds label 3 to the packet.

C.

Before forwarding a packet destined for any IP address, the device removes labels from the packet.

D.

Before forwarding a packet destined for 3.3.3.3, the device adds label 1027 to the packet.

Buy Now
Exam Code: H12-831_V1.0
Exam Name: HCIP-Datacom-Advanced Routing & Switching Technology V1.0
Last Update: Nov 18, 2026
Questions: 244
H12-831_V1.0 pdf

H12-831_V1.0 PDF

$22.5  $89.99
H12-831_V1.0 Engine

H12-831_V1.0 Testing Engine

$25  $99.99
H12-831_V1.0 PDF + Engine

H12-831_V1.0 PDF + Testing Engine

$35  $139.99