In the preparation phase of a migration project, the software and hardware need to be checked. Match the operation objects in the preparation phase with the corresponding operation contents.

Network administrators can run the clock timezone command to set the time zone of a device. If two network devices have different time zone settings, they cannot establish a neighbor relationship using a dynamic routing protocol.
Options:
The figure shows a Link-LSA generated by an OSPFv3 router. How many global unicast addresses are configured for the interface?
On the OSPF network shown in the figure, the cost values of links are marked. OSPF IP FRR is enabled on R1, and the maximum load-balancing 8 command is configured in the OSPF process. If a service passes through the path R1 → R5 → R3 to reach 10.0.3.3/32, which of the following is the backup outbound interface for the service?

The figure shows the network and VPN plan of an enterprise. Match the sites that can communicate with each other. (Note: A site cannot be matched with itself. For example, Site 1 cannot be matched with Site 1.)

On the IS-IS IPv6 network shown in the figure, multi-topology is enabled on all routers.
The ipv6 default-route-advertise always level-1 command is configured in the IS-IS process of R4.

Which of the following routers does not have the default route in its routing table?
When configuring port security on a switch, the administrator also enables static MAC address flapping detection. If static MAC address flapping occurs, the switch takes the configured action to protect the interface.
Match the names of interface security protection actions with corresponding operations.

On the network shown in the figure, IS-IS IPv6 runs on R2, R6, and R3, and the IPv6 address of Loopback0 on R6 is 2000::6/128. OSPFv3 runs on other links. Area 1 is a stub area, and area 2 is an NSSA. ISIS routes are imported to OSPFv3 on R2 and R3. Which of the following methods can enable R4 to ping 2000: :6?

MPLS supports nesting of multiple labels. After receiving an MPLS packet, a device first processes the label next to the Layer 2 header, that is, the top MPLS label.
The device operating environment is crucial for stable device operating, including the equipment room, power supply, and heat dissipation. Maintenance personnel must be on site to maintain the device operating environment.