300-410 Exam Dumps - Cisco CCNP Enterprise Questions and Answers

Refer to the exhibit.

Which interface configuration must be configured on the spoke A router to enable a dynamic DMVPN tunnel with the spoke B router?

What is a role of route distinguishers in an MPLS network?

An engineer configured a leak-map command to summarize EIGRP routes and advertise specifically loopback 0 with an IP of 10.1.1.1.255.255.255.252 along with the summary route. After finishing configuration, the customer complained not receiving summary route with specific loopback address. Which two configurations will fix it? (Choose two.)

Which configuration adds an IPv4 interface to an OSPFv3 process in OSPFv3 address family configuration?

During the maintenance window an administrator accidentally deleted the Telnet-related

configuration that permits a Telnet connection from the inside network (Eth0/0) to the outside of the networking between Friday – Sunday night hours only. Which configuration resolves the issue?

A)

B)

C)

D)

Refer to the following output:

Router#show ip nhrp detail

10.1.1.2/8 via 10.2.1.2, Tunnel1 created 00:00:12, expire 01:59:47

TypE. dynamic, Flags: authoritative unique nat registered used

NBMA address: 10.12.1.2

What does the authoritative flag mean in regards to the NHRP information?

Which attribute eliminates LFAs that belong to protected paths in situations where links in a network are connected through a common fiber?

Which label operations are performed by a label edge router?

Refer to the exhibit.

Network operations cannot read or write any configuration on the device with this configuration from the operations subnet. Which two configurations fix the issue? (Choose two.)

Refer to the exhibit.

The network administrator configured VRF lite for customer A. The technician at the remote site misconfigured VRF on the router. Which configuration will resolve connectivity for both sites of customer_a?

Refer to the exhibit.

Which configuration configures a policy on R1 to forward any traffic that is sourced from

the 192.168.130.0/24 network to R2?

Which protocol does MPLS use to support traffic engineering?

Which protocol does VRF-Lite support?

Refer to the exhibit.

An engineer is trying to block the route to 192.168.2.2 from the routing table by using the

configuration that is shown. The route is still present in the routing table as an OSPF route. Which action blocks the route?

Which command displays the IP routing table information that is associated with VRF-Lite?