Summer Sale 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: Board70

300-410 Exam Dumps - Cisco CCNP Enterprise Questions and Answers

Question # 169

Refer to the exhibit.

Which subnet is redistributed from EIGRP to OSPF routing protocols?

Options:

A.

10.2.2.0/24

B.

10.1.4.0/26

C.

10.1.2.0/24

D.

10.2.3.0/26

Buy Now
Question # 170

Refer to the exhibit.

A company is evaluating multiple network management system tools. Trending graphs generated by SNMP data are returned by the NMS and appear to have multiple gaps. While troubleshooting the issue, an engineer noticed the relevant output. What solves the gaps in the graphs?

Options:

A.

Remove the exceed-rate command in the class map.

B.

Remove the class map NMS from being part of control plane policing.

C.

Configure the CIR rate to a lower value that accommodates all the NMS tools

D.

Separate the NMS class map in multiple class maps based on the specific protocols with appropriate CoPP actions

Buy Now
Question # 171

When provisioning a device in Cisco DNA Center, the engineer sees the error message “Cannot select the device. Not compatible with template”.

What is the reason for the error?

Options:

A.

The template has an incorrect configuration.

B.

The software version of the template is different from the software version of the device.

C.

The changes to the template were not committed.

D.

The tag that was used to filter the templates does not match the device tag.

Buy Now
Question # 172

Refer to the exhibit.

Why is the remote NetFlow server failing to receive the NetFlow data?

Options:

A.

The flow exporter is configured but is not used.

B.

The flow monitor is applied in the wrong direction.

C.

The flow monitor is applied to the wrong interface.

D.

The destination of the flow exporter is not reachable.

Buy Now
Question # 173

Refer to the exhibit.

An administrator noticed that after a change was made on R1, the timestamps on the system logs did not match the clock. What is the reason for this error?

Options:

A.

An authentication error with the NTP server results in an incorrect timestamp.

B.

The keyword localtime is not defined on the timestamp service command.

C.

The NTP server is in a different time zone.

D.

The system clock is set incorrectly to summer-time hours.

Buy Now
Question # 174

What is a prerequisite for configuring BFD?

Options:

A.

Jumbo frame support must be configured on the router that is using BFD.

B.

All routers in the path between two BFD endpoints must have BFD enabled.

C.

Cisco Express Forwarding must be enabled on all participating BFD endpoints.

D.

To use BFD with BGP, the timers 3 9 command must first be configured in the BGP routing process.

Buy Now
Question # 175

During the maintenance window an administrator accidentally deleted the Telnet-related

configuration that permits a Telnet connection from the inside network (Eth0/0) to the outside of the networking between Friday – Sunday night hours only. Which configuration resolves the issue?

A)

B)

C)

D)

Options:

A.

Option A

B.

Option B

C.

Option C

D.

Option D

Buy Now
Question # 176

Refer to the exhibit.

After applying IPsec, the engineer observed that the DMVPN tunnel went down, and both

spoke-to-spoke and hub were not establishing. Which two actions resolve the issue? (Choose two.)

Options:

A.

Configure the crypto isakmp key cisco address 192.1.1.1 on R2 and R3

B.

Configure the crypto isakmp key cisco address 0.0.0.0 on R2 and R3.

C.

Change the mode from mode tunnel to mode transport on R3

D.

Change the mode from mode transport to mode tunnel on R2.

E.

Remove the crypto isakmp key cisco address 10.1.1.1 on R2 and R3

Buy Now
Question # 177

Refer to the exhibit.

Which interface configuration must be configured on the spoke A router to enable a dynamic DMVPN tunnel with the spoke B router?

Options:

A.

Option A

B.

Option B

C.

Option C

D.

Option D

Buy Now
Question # 178

Which command is used to check IP SLA when an interface is suspected to receive lots of traffic with options?

Options:

A.

show track

B.

show threshold

C.

show timer

D.

show delay

Buy Now
Question # 179

An engineer configured a company’s multiple area OSPF head office router and Site A cisco

routers with VRF lite. Each site router is connected to a PE router of an MPLS backbone.

After finishing both site router configurations, none of the LSA 3,4 5, and 7 are installed at Site A router. Which configuration resolves this issue?

Options:

A.

configure capability vrf-lite on Site A and its connected PE router under router ospf 1 vrf abc

B.

configure capability vrf-lite on Head Office and its connected PE router under router ospf 1 vrf abc

C.

configure capability vrf-lite on both PE routers connected to Head Office and Site A routers under routtr ospf 1 vrf abc

D.

configure capability vrf-lite on Head Office and Site A routers under router ospf 1 vrf abc

Buy Now
Question # 180

Refer to the exhibit.

Network operations cannot read or write any configuration on the device with this configuration from the operations subnet. Which two configurations fix the issue? (Choose two.)

Options:

A.

Configure SNMP rw permission in addition to community ciscotest.

B.

Modify access list 1 and allow operations subnet in the access list.

C.

Modify access list 1 and allow SNMP in the access list.

D.

Configure SNMP rw permission in addition to version 1.

E.

Configure SNMP rw permission in addition to community ciscotest 1.

Buy Now
Question # 181

Refer to the exhibit.

AAA server 10.1.1.1 is configured with the default authentication and accounting settings, but the switch cannot communicate with the server Which action resolves this issue?

Options:

A.

Match the authentication port

B.

Match the accounting port

C.

Correct the timeout value.

D.

Correct the shared secret.

Buy Now
Question # 182

Which configuration adds an IPv4 interface to an OSPFv3 process in OSPFv3 address family configuration?

Options:

A.

Router ospf3 1 address-family ipv4

B.

Router(config-router)#ospfv3 1 ipv4 area 0

C.

Router(config-if)#ospfv3 1 ipv4 area 0

D.

Router ospfv3 1 address-family ipv4 unicast

Buy Now
Question # 183

Which protocol is used in a DMVPN network to map physical IP addresses to logical IP addresses?

Options:

A.

BGP

B.

LLDP

C.

EIGRP

D.

NHRP

Buy Now
Exam Code: 300-410
Exam Name: Implementing Cisco Enterprise Advanced Routing and Services (300-410 ENARSI)
Last Update: Jun 16, 2026
Questions: 642
300-410 pdf

300-410 PDF

$28.5  $94.99
300-410 Engine

300-410 Testing Engine

$33  $109.99
300-410 PDF + Engine

300-410 PDF + Testing Engine

$43.5  $144.99