Which Cisco WLC feature allows grouping of APs into a logical set for RF management?
A customer has two locations named building 1 and building 2 Each location has a Cisco wireless network with these components
Building 1
• 2 Cisco Catalyst 9800 Series Wireless Controllers in a high availability cluster
• 50 Cisco Catalyst 9100 APs
• Contractor SSID in VLAN 100
• Corporate SSID in VLAN 200
• mobility group configured to the building 2 WLCs
Building 2
• 2 Cisco Catalyst 9800 Series Wireless Controllers in a high availability cluster
• 20 Cisco Catalyst 9100 APs
• Contractor SSID in VLAN 300
• Corporate SSID in VLAN 400
• mobility group configured to the building 1 WLCs
The customer has a new security requirement mandating that all contractor SSID traffic must terminate on VLAN 100 on the building 1 WLCs for all locations. Which design approach must the engineer take?
Which feature must be incorporated into the network design to allow seamless Layer 3 roaming between controllers?
Which two considerations must a network engineer have when planning for voice over wireless roaming? (Choose two.)
A wireless engineer is designing a wireless network to support real time applications over wireless. Which IEEE protocol must the engineer enable on the WLC so that neighbor list radio management packets are sent to the wireless devices?
A network engineer is configuring high availability on an access point. What is the maximum number of controllers that can be configured?
A network engineer is designing a new wireless network for a campus The network must include these requirements
• optimized performance
• avoid Interference
• availability in high-density areas
• roaming
Which two approaches must be taken? (Choose two.)
An enterprise is using the wireless network as the main network connection for corporate users and guests. To wireless network availability. Two Standalone controllers are installed in the head office. APs are connected to the controllers using a round-robin approach to load balance the traffic. After a power cut, the wireless clients disconnect while roaming. An engineer tried eping from the controller but faits. Which protocol needs to be allowed between the networks that the controllers are installed?
As part of a wireless site survey in a hospital, an engineer needs to identify potential Layer 1 interferers. In which two areas is the engineer most likely to find sources of 2.4 GHz and 5 GHz RF noise? (Choose two.)
Refer to the exhibit.
A network engineer has identified that during a recent controller failure, several APs failed over to the tertiary controller instead of the secondary controller. The configuration from one of the APs is provided. Which design consideration led to the issue?
TESTED 24 Feb 2026
