300-425 Exam Dumps - Cisco CCNP Enterprise Questions and Answers

FlexConnect mode is ideal for branch offices and remote locations where it’s necessary to minimize wireless traffic tunneled back to the Wireless LAN Controller (WLC). In FlexConnect mode, APs can perform client authentication locally and bridge traffic onto the local network. References: CCNP Enterprise Wireless Design ENWLSD 300-425 and Implementation ENWLSI 300-430 Official Cert Guide.

 For a WLAN design that supports services like internet, email, voice, and database access, a signal strength of -67 dBm is considered good for voice and streaming services. A 25-dB SNR (Signal-to-Noise Ratio) is also desirable for high-quality voice and video applications, and a maximum of 1 percent packet loss is acceptable to ensure reliable connectivity and service quality.

https://www.cisco.com/c/en/us/support/docs/wireless/5500-series-wireless-controllers/116057site-survey-guidelines-wlan-00.html

Micro cells with reduced power levels are suitable for environments with a high concentration of wireless clients and multimedia applications, as they help manage interference and allow for better roaming capabilities. References: ENWLSD 300-425 Official Cert Guide.

 When a data path mobility tunnel fails to come up, one of the troubleshooting steps is to check if the necessary ports are open and not being blocked by any firewalls in the path. Since the mobility tunnel uses CAPWAP, which operates on UDP ports 16666 (control path) and 16667 (data path), establishing a Telnet connection to the firewall on port 16666 can help determine if the control path is open and if there are any issues that need to be addressed3.

To mitigate increased co-channel interference and retransmissions after adding an AP, Transmit Power Control (TPC) and Dynamic Channel Assignment (DCA) can be effective. TPC adjusts AP transmit power based on real-time analysis of the wireless environment, reducing interference by lowering power where necessary. DCA dynamically changes channel assignments based on current RF conditions to optimize performance and minimize interference.

The survey model described is used for location services, VoIP, data, and video. The placement of APs on exterior walls, building corners, and major turns helps ensure consistent coverage and signal strength for a variety of applications, including precise location tracking and high-quality voice and video communications. References: Designing Cisco Enterprise Wireless Networks (ENWLSD 300-425)

The command debug mobility handoff enable is used to validate the mobility control packets between Wireless LAN Controllers (WLCs). This command enables debugging of the handoff process, which is critical for ensuring seamless client roaming between controllers. When WLCs are separated by firewalls, it is essential to confirm that mobility control packets can traverse these firewalls without being dropped or rejected. The debug mobility handoff enable command allows network administrators to monitor the handoff process and troubleshoot any issues that may prevent successful client roaming.

Setting the Anchor priority for the primary controller to 1 ensures that clients connect to the primary controller first. The Anchor priority is a value assigned to each controller within a mobility group to determine the order in which clients should connect to the controllers. A lower priority value has higher precedence. Therefore, by setting the primary controller’s Anchor priority to 1, it becomes the preferred controller for client connections. If the primary controller fails, clients are then pushed to the secondary controller, which should have a higher Anchor priority value.

In a global mesh deployment, using redundant controllers in the least restrictive regulatory domain ensures the highest number of channels available for backhaul. This design accommodates the varying regulatory constraints of different regions by adhering to the domain with the most lenient channel availability.