Refer to the exhibit An engineer deploys a Cisco Unified Border Element for SIP trunk interconnection to an ITSP The engineer performs test calls but there is no audio when the called party picks up the phone. What must the engineer do to resolve the issue?
Exhibit.
Refer to the exhibit. All calls from site A to site B are failing, and the issue has been identified as a media negotiation problem. Which configuration change resolves the issue?
Refer to the exhibit.
ILShas been configured between two hubs using this configuration. The hubs appear to register successfully, butILSis not functioning as expected. Which configuration step is missing?
An engineer Is configuring a Cisco Unified Border Element. The SIP ITSP requires a DNIS of 10-digits and DTMF tones sent in the RTP stream on the outbound leg of a call. Which code completes this configuration?
A)
B)
C)
D)
Refer to the exhibit. When setting up a new connection to Cisco UCM, the engineer must use out-of-band DTMF. Which configuration meets this requirement?
Which top-level IOS command is needed to begin the configuration of a Cisco Unified Communications Manager Express gateway to enable phones to be registered via SIP?
The same digits sent in OOB, as well as in-band on the Cisco Unified Border Element, are being interpreted as duplicate digits by the receiving end. Which configuration must an engineer implement to resolve this issue?
Management wants to change the initial announcements for one of the existing call hunt groups. A new set of announcement audio file was provided. Which two configuration steps must the administrator take to accomplish this change? (Choose two.)
An engineer must configure call queuing under a Hunt Pilot. After the engineer receives the audio file that will be played to callers during queuing, which two steps should be taken to complete the configuration? (Choose two.)
Which configuration must an administrator perform to display Translation Pattern operations in Cisco Unified Communications Manager SDL traces?
TESTED 15 Jun 2025
