Authentic CWNP Certification Exam CWNA-109 Questions Answers

 A Wi-Fi scanner is a basic tool that can be used to easily locate areas of high co-channel interference. A Wi-Fi scanner is a software application that can run on a laptop, tablet, smartphone, or other device that has a Wi-Fi adapter. A Wi-Fi scanner can scan the wireless environment and display information about the detected access points and client stations, such as their SSID, BSSID, channel, signal strength, security, and data rate. A Wi-Fi scanner can also show the channel utilization and overlap of different access points, which can indicate the level of co-channel interference. Co-channel interference is a type of interference that occurs when multiple access points use the same or adjacent channels within the same coverage area. Co-channel interference can reduce the throughput and performance of the WLAN, as the access points and client stations have to contend for the channel access and avoid collisions. To identify areas of high co-channel interference, a Wi-Fi scanner can be used to measure the signal strength and channel utilization of different access points and compare them with a threshold or a baseline. Alternatively, a Wi-Fi scanner can also use a color-coded heat map to visualize the co-channel interference level in different locations. References: 1, Chapter 7, page 279; 2, Section 4.3

Impedance is the measure of opposition to the flow of alternating current (AC) in a circuit. Impedance mismatch occurs when the impedance of the radio does not match the impedance of the antenna or the cable. This causes some of the transmitted or received signal to be reflected back, resulting in a loss of power and efficiency. The voltage standing wave ratio (VSWR) is a metric that indicates the amount of impedance mismatch in a transmission line. A higher VSWR means a higher impedance mismatch and a lower signal quality. A VSWR of 1:1 is ideal, meaning there is no impedance mismatch and no reflected power. A VSWR of 2:1 means that for every 2 units of forward power, there is 1 unit of reflected power12.

The other options are not correct because they do not affect the VSWR in RF cables. A high gain yagi antenna or a high gain parabolic dish antenna can increase the signal strength and directionality, but they do not cause impedance mismatch in the cable. Radio output power above 100 mW but below 400 mW is within the acceptable range for most WLAN devices and does not cause excessive VSWR in the cable3.

References: 1:CWNA-109Official Study Guide, page 77 2: VSWR 3:CWNA-109Official Study Guide, page 81

The response that you should give to your manager’s suggestion of implementing the security practices of disabling the broadcasting of the SSID in Beacons and configuring the access points not to respond to Probe Request frames that have a null SSID field is that any 802.11 protocol analyzer can see the SSID in clear text in frames other than Beacons frames. This negates any security benefit of trying to hide the SSID in Beacons and Probe Response frames. The SSID (Service Set Identifier) is a human-readable name that identifies a WLAN and allows users to connect to it. The SSID is transmitted in clear text in several types of 802.11 frames, such as Beacon frames, Probe Request frames, Probe Response frames, Association Request frames, Association Response frames, Reassociation Request frames, and Reassociation Response frames. Some people may think that hiding the SSID can improve the security of the WLAN by making it invisible to potential intruders. However, this is not true, as hiding the SSID only removes it from Beacon frames and Probe Response frames that have a null SSID field. The SSID is still present in other types of frames that can be easily captured and analyzed by any 802.11 protocol analyzer or wireless scanner tool. Therefore, hiding the SSID does not provide any real security benefit and may even cause some compatibility and performance issues for legitimate users. References: 1, Chapter 4, page 133; 2, Section 4.1