Free 350-501 Cisco Updates

Page: 24 / 33

Question 96

Refer to the exhibit.

An engineer with an employee 10:4350:47:853 is implementing IS-IS as the new routing protocol in the network. All routers in the network operate as Level 2 routers in the same private autonomous system, and the three branches are connected via dark fibre. The engineer has already implemented IS-IS on router R1 with NET address 49.0133.532b.ca14.6915.21311.F40F.1B3a.ba10.00. Which IS-IS NET address configuration must be implemented on R3 to establish IS-IS connectivity?

Options:

49.0133.532b.ca14.6915.21311.f40f.1b4a.bb87.00

49.0135.332b.ca14.6975.28371.1721.1b3b.ca11.10

48.0133.532b.ca14.6915.21311.f40f.1626.bb98.00

49.0133.532b.ca14.6915.21311.1721.1b4a.0013.01

Question 97

Which MPLS design attribute can you use to provide Internet access to a major customer through a separate dedicated VPN?

Options:

The customer that needs the Internet access service is assigned to the same RTs as the Internet gateway

The Internet gateway inserts the full Internet BGP routing table into the Internet access VPN

The Internet gateway router is connected as a PE router to the MPLS backbone.

The CE router supports VRF-Ute and the full BGP routing table.

Question 98

Refer to the exhibit.

The engineering team wants to limit control traffic on router RX with the following IP address assignments:

• Accepted traffic for router: 10.0.0.0/24

• NOC users IP allocation: 192.168.10.0/24

Which additional configuration must be applied to RX to apply the policy for MSDP?

Options:

RX(config)#access-list 151 permit tcp any gt 1024 10.10.0.0 0.0.0.255 eq 639

RX(config)#access-list 151 permit tcp any eq 639 10.10.0.0 0.0.0.255 gt 1024 established

RX(config)#access-list 150 permit tcp any gt 1024 10.0.0.0 0.0.0.255 eq 639

RX(config)#access-list 150 permit tcp any eq 639 10.0.0.0 0.0.0.255 gt 1024 established

RX(config)#access-list 151 permit tcp any 10.0.0.0 0.0.0.255 eq 639

RX(config)#access-list 151 permit udp any 10.0.0.0 0.0.0.255 eq 639

RX(config)#access-list 150 permit tcp any 10.0.0.0 0.0.0.255 eq 639

RX(config)#access-list 150 permit udp any 10.0.0.0 0.0.0.255 eq 639

Question 99

Refer to the exhibit.

An engineer must configure router R2 as the new P router in the network. Which configuration must be applied to R2 to enable LDP-IGP Sync on its L2 IS-IS adjacencies?