ITFAS-Level-1 Exam Dumps - NICET Inspection and Testing of Fire Alarm Systems Questions and Answers

Amultimeteris the standard tool used by fire alarm technicians to measure bothbattery voltageandcharging current.

NFPA 72 (2022), Table 14.4.3.2 – Testing Methods for Batteries:

Testing includes checking the voltage and current — commonly done using a multimeter.

Multimeters are capable of readingDC voltage(for battery levels) andamperage(for charge current).

When aDACTis the only method of off-premises signal transmission, itmustbe connected totwo separate telephone linesto ensure redundancy in case one line fails.

NFPA 72 (2022), Section 26.6.4.4.4.1:

“DACTs shall be connected to two separate phone lines (one primary, one secondary). Loss of the primary line shall result in a supervisory signal.”

This redundancy ensures system reliability when using traditional telephone-based communication.

Correct answer: D. Two separate phone lines are required

===========

Duct smoke detectors must be inspected visually to check for cleanliness, mounting condition, and airflow alignment. The minimum frequency isquarterly.

NFPA 72 (2022), Table 14.3.1 — Visual Inspection Frequencies:

"Duct detectors (smoke)" → Frequency: Quarterly

This helps ensure proper functionality in HVAC systems.

Correct answer: B. Quarterly

===========

Forsealed lead-acid batteries, NFPA 72 specifies that their condition be verified by checkingspecific gravity, which indicates battery charge status and health.

NFPA 72 (2022), Table 14.4.3.2 — Testing Methods:

Lead-acid batteries shall be tested semiannually by measuring specific gravity.

If batteries are sealed and specific gravity cannot be tested, voltage and visual checks are used instead.

Correct answer: C. By verifying specific gravity

===========

Animpairmentis a formal condition defined in NFPA 72 when a system or portion of it is not functional and may fail during an emergency. This is a critical safety concern.

NFPA 72 (2022), Section 3.3.149 – Impairment (Fire Alarm Systems):

“A condition where a fire protection or life safety system or a portion thereof is out of service.”

Also supported by Section 10.21.1:

Which details handling of system impairments and the need for proper management, notification, and restoration.

Correct answer: A. Impairment

===========

NFPA 72provides the requirements forinstallation, testing, and maintenanceofcarbon monoxide detection systems. This includes required signals, testing intervals, and integration with fire alarm control units.

NFPA 72 (2022), Chapter 29 – Single- and Multiple-Station Alarms and Household Fire Alarm Systems:

Also coversCO detection and testing proceduresper Section 29.10.

NFPA 720(the former CO detection standard) was integrated into NFPA 72 in recent editions.

Correct answer: C. NFPA 72

===========

Sound level readings for fire alarm audible notification appliances must be taken at a consistent, standardized height to ensure compliance with required dBA levels.

NFPA 72 (2022), Section 18.4.6.1:

“Sound pressure level measurements shall be taken with a sound level meter positioned 5 ft (1.5 m) above the floor in the area required to be served by the system.”

This applies to bothpublic mode(e.g., schools, offices) andprivate mode(e.g., staff-only zones like hospitals).

Correct answer: B. 5.0 feet (1.5 meters)

===========

NFPA requiresdaily visual inspectionof fire alarm control equipment if it isnot monitored(not connected to a supervising station). This is to manually check for trouble lights, alarms, or other fault indications.

NFPA 72 (2022), Table 14.3.1 — Control Equipment (not monitored):

Visual inspection frequency: Daily

Correct answer: A. Daily

===========

NFPA 72 requires smoke alarms in residential settings to be replaced every10 years, even if they have not shown any signs of failure.

NFPA 72 (2022), Section 29.8.1.4:

“Unless otherwise recommended by the manufacturer, smoke alarms shall be replaced when they fail to respond to operability tests or have been in service for 10 years.”

Correct answer: C. 10

===========

Engine-driven generators used for emergency power arenot governed directly by NFPA 72. Instead, their installation and testing requirements are found in:

NFPA 110 – Standard for Emergency and Standby Power Systems

NFPA 110 (2022), Chapter 8details howengine-driven generatorsmust be tested, including runtime, load testing, and maintenance intervals.

NFPA 72 references NFPA 110whenever standby/emergency power is used for fire alarm systems.

Correct answer: D. NFPA 110