ITFAS-Level-1 Exam Dumps - NICET Inspection and Testing of Fire Alarm Systems Questions and Answers

NFPA 72 specifies a strict timeframe for the automatic switchover tosecondary powerafter loss of primary power.

NFPA 72 (2022), Section 10.6.7.1.2:

“Transfer to secondary power shall occur within 30 seconds after loss of primary power.”

This ensures uninterrupted monitoring and alarm functions during outages.

Correct answer: B. 30

===========

Fire alarm systems that communicate via telephone lines are required to monitor those lines for disconnection. If theprimary line fails, it must be reported as asupervisory condition, and the system will attempt communication via thesecondary line.

NFPA 72 (2022), Section 26.6.4.4.4.1:

"A single communications technology shall be monitored for integrity. Loss of the supervising line shall result in a supervisory signal..."

So, if theprimary phone line is disconnected, the correct system response is to issue asupervisory signal, not a general alarm or just a local alert.

Correct answer: D. Supervisory condition

===========

Asupervisory signalindicates a condition thatrequires attention but is not an alarm. In sprinkler systems, one of the most common supervisory signals comes from avalve tamper switch, indicating a partially closed valve, or sometimes awaterflow switch resetissue.

NFPA 72 (2022), Section 3.3.269:

"Supervisory Signal — A signal indicating the need for action in connection with the supervision of guard tours, the fire suppression systems, or equipment or maintenance features of related systems."

Also:Table A.10.14.2.1

Shows thatwaterflow valves and tamper switchesare typical sources of supervisory signals.

So the correct answer — awaterflow alarmimplies something abnormal with the fire protection system, possibly indicating a tamper switch or system supervisory issue.

Correct answer: D. A waterflow alarm has been activated

===========

Duct detectors are used to shut down air handling systems to prevent smoke from circulating. NFPA 72 requires that these detectors and their shutdown functions be testedannually.

NFPA 72 (2022), Table 14.4.3.2 – Testing Frequencies:

"Duct-type smoke detectors with HVAC shutdown" → Frequency: Annually.

The test must verifydetector functionandHVAC control activation.

Correct answer: D. Annually

Normally, smoke detector sensitivity testing is requiredevery two years, butNFPA 72 allows extension up to five yearsif thedetectors have not experienced frequent nuisance alarmsand accuraterecords of performanceare maintained.

NFPA 72 (2022), Section 14.4.4.3.2:

“Where detectors are cleaned and maintained and where records of nuisance alarms and changes in detector locations are kept, the sensitivity testing interval shall be permitted to be extended to 5 years.”

Keeping a log of nuisance alarms helps assess the reliability of the detectors over time.

Correct answer: C. Records of nuisance alarms shall be maintained