NSE7_SDW-7.2 Exam Dumps - Fortinet NSE 7 Network Security Architect Questions and Answers

Set priority 10.

Set cost 15.

Set load-balance-mode source-ip-ip-based.

Set source 100.64.1.1.

FortiGate performs route lookups for new sessions only.

Regular policy routes have precedence over SD-WAN rules.

SD-WAN rules have precedence over ISDB routes.

By default, SD-WAN members are skipped if they do not have a valid route to the destination.

By default, SD-WAN rules are skipped if the best route to the destination is not an SD-WAN member.

It does not allow you to monitor the status of SD-WAN members.

It is enabled or disabled on a per-ADOM basis.

It is enabled by default.

It uses templates to configure SD-WAN on managed devices.

get router info routing-table all

diagnose debug application ike

diagnose vpn tunnel list

get ipsec tunnel list

The traffic will be load balanced across all three overlays.

The traffic will be routed over T_INET_0_0.

The traffic will be routed over T_MPLS_0.

The traffic will be routed over T_INET_1_0.

The ISDB is dynamically updated and reduces administrative overhead.

The ISDB requires application control to maintain signatures and perform load balancing.

The ISDB applies rules to traffic from specific sources, based on application type.

The ISDB contains the IP addresses and port ranges of well-known internet services.

The session information output displays no SD-WAN-specific details.

All SD-WAN rules have the default and gateway setting enabled.

Traffic does not match any of the entries in the policy route table.

Traffic is load balanced using the algorithm set for the v4-ecmp-mode setting.

You can use metadata variables only to define interface members and the gateway IP.

All SD-WAN template fields support metadata variables.

Any field Identified with a dollar sign ($) in a magnifying glass.

Any field identified with an "M" in a circle.

type must be set to static.

mode-cfg must be enabled.

exchange-interface-ip must be enabled.

add-route must be disabled.