Which two statements describe Ethernet switching mode on Cisco UCS 6100 Series Fabric Interconnects? (Choose two.)
Drag and drop the feature descriptions from the left onto the correct UCS Fabric Interconnect modes on the right.
An engineer must connect a Cisco UCS B-Series based system to an existing large storage area network fabric. The deployment must support hardware-based load balancing, prevent Fibre Channel domain ID exhaustion, and enable all blade servers to be in the same VSAN. Which set of actions meets the requirements?
Which two configurations allow for routing traffic between two VDCs? (Choose two.)
Which two features are provided by deploying an OOB management network in a Cisco Nexus data center? (Choose two.)
A network consultant evaluates the Ethernet Adapter Policy configuration to be applied to the Cisco UCS blade servers. The policy must minimize latency and increase throughput for sensitive applications. The solution must increase the CPU data cache hit rate to meet these requirements Which policy is required?
Refer to the exhibit.
Server 1 fails to connect to the storage array over the Storage Area Network (SAN) of the Cisco NDS 9000 Series Switch. The requirements are to redesign the storage network and keep these considerations in mind:
The traffic from each of the server must be redundant and isolated.
The design must tolerate hardware and software failures and upgrades of SAN fabric devices.
Which action must be taken to meet these requirements?
An engineer must design a Cisco UCS environment that will connection to a storage area network. The solution must include support for these conditions:
• connectivity to the existing 10 Gigabit Ethernet network
• booting the server infrastructure from the network
• integration with the existing Fibre Channel storage arrays
• lossless data transfer
Which solution should be used to meet these requirements?
A company must implement a multitenant environment for DEV and PROD application teams. The design must support end-to-end route isolation for remote external sites, overlapping IP ranges, and fast, transparent application deployment. Which solution meets the objectives?
An engineer must deploy a Cisco HyperFlex system at two data centers. For redundancy reasons, the setup must achieve data protection in case of an entire site failure. The data must be available on both sites at all times to keep the recovery time objective to a minimum.
Which Cisco HyperFlex deployment model meets these requirements?
TESTED 24 Feb 2026
