Which type fields can an engineer use to identify an iSCSI participant? (Choose two.)
A network architect designs a high-availability architecture for the Cisco UCS Fabric interconnects that installed in a data center. The architecture must support clustering and redundancy. Which architecture meets these requirements?
Refer to the exhibit. An engineer builds a data center network design using EVPN technology. Within the design, the fabric acts as a gateway. Traffic from host X to host Y must pass through the Cisco ASA firewall for deep packet inspection and increased security. Which firewall deployment must the engineer choose to accomplish this goal?
Refer to the exhibit. A Cisco engineer is implementing a customer data center design and must configure Cisco MDS 9000 Series Switches. The configuration has the required IP addresses on each SAN. The requirement is that each FCIP is a separate E(ISL). and the FCIP links must connect to different switches across the two SAN islands. Also, the Fibre Channel traffic is to be load-balanced across the FCIP link. After the engineer configures the FCIP profiles and interfaces they want to enable QoS for the link. Which types of values are needed for the DSCP to mark the IP packets?
An engineer must implement a WWPN pool for the vHBA template inside the Cisco UCS Manager. The template is used to connect a Cisco UCS B-Series blade to an external storage array.
Which addressing sequence accomplishes this goal?
Which multicast rendezvous point redundancy mode is valid for Bidirectional PIM?
Refer to the exhibit. An engineer working for a service provider with an employee ID: 4800:35-849 must perform the mapping of Fibre Channel LUN targets lo the indicated iSCSI virtual target. Which configuration shows the requited mapping?
An end user is experiencing network latency when accessing a database in a disaster recovery site. The monitoring team concluded that the database was writing simultaneously to the storage arrays on the primary and disaster recovery sites.
Which design resolves this issue?
An engineer must use OTV for layer 2 connectivity between data centers to support virtual machine between the customer sites. To support this requirement, the engineer must ensure the existence of the same default gateway on both sites. Additionally, the operations team report high bandwidth utilization on site A and wants to optimize the outbound traffic flows to use a DC exit point. Which feature must be used to meet these requirement?
A Cisco engineer is discussing a data center design scenario that consists of 24 Cisco UCS B200M6 Wade servers. 2 Cisco UCS 6454 Fabric Interconnects, and 3 Cisco UCS 5108 server chassis In the proposed configuration, the server links, which are vNICs on the blades, are associated with a single uplink port Server-to-server Layer 2 traffic is locally switched, server-to-network traffic goes out on its pinned uplink port, and each server MAC address must be learned before traffic can be forwarded to it Which feature stipulates that traffic is forwarded to a server only if it is received on a pinned uplink port for this server?
TESTED 24 Feb 2026
