JNCIS-SP JN0-363 Updated Exam

In IS-IS, Level 1 routes are usually contained within the same area and Level 2 routes are used to interconnect different areas. By default, routes from Level 1 are redistributed into Level 2, and vice versa, to ensure reachability between areas.

References

• Juniper Networks Technical Documentation on IS-IS

By default, IS-IS protocol leaks routing information from a Level 1 area to a Level 2 area. However, to leak routing information from a Level 2 area to a Level 1 area, an export policy must be explicitly configured.

When establishing an EBGP session, it's necessary to specify both the local AS number and the local address that the session will use. The local address is required for establishing the TCP connection for BGP. The local AS must be specified to identify the autonomous system of the router.References:

• Configuring BGP, Juniper TechLibrary
• BGP Peers and BGP Sessions, Juniper TechLibrary

The exhibit shows an aggregate route configuration for the network172.21.0.0/22, which would summarize the specific networks172.21.0.0/24,172.21.1.0/24, and172.21.2.0/24. For an aggregate route to be active, it must have contributing routes in the routing table. If the route is hidden, it usually means there are no contributing routes that are active or the policy applied to the aggregate does not match any of the specific routes.Therefore, the first step in troubleshooting would be to verify that there are indeed active contributing routes for the aggregate to be valid.

References:

• Juniper documentation on routing policies and aggregates: Junos OS Routing Policies, Firewall Filters, and Traffic Policers User Guide

On a Junos device, trunk ports are configured to receive and transmit tagged traffic only, while access ports are configured to receive and transmit untagged traffic.References:

• Understanding Access and Trunk Interfaces, Juniper Networks Documentation
• VLANs and Trunking, Juniper Networks Documentation