An engineer must configure OSPFv2 connectivity between a pair of Cisco Nexus switches. The connection between the switches must meet these requirements:
Use unicast for updates.
Use decentralized communication of updates.
Full adjacency between switches.
Which configuration is needed to meet these requirements?
An engineer must configure OSPF routing on Cisco Nexus 9000 Series Switches. The IP subnet of the Eth 1/2 interface for both switches must be advertised via OSPF. However, these interfaces must not establish OSPF adjacency or send routing updates. The current OSPF adjacency over the interface Eth1/1 on SW1 and Eth1/1 on SW2 must remain unaffected. Which configuration must be applied to both Nexus switches to meet these requirements?
What happens when the install all epid bootflash:m9000-pkg2-9.2.2.epid module all fan-module all bar all command is run on the Cisco MDS 9000 Series Director Switch?
Refer to the exhibit. A Cisco Nexus Dashboard Fabric Controller (NDFC) manages the LAN network using the interface mgmt0. The management interface of the Nexus Dashboard is Layer 2 adjacent to the mgmt0 interface of the Nexus 9000 Series Switch. Which IP address must be allocated to the mgmt0 interface of the NDFC to manage the LAN network?
What occurs when running the command install deactivate
< filename > while a software maintenance upgrade is performed on a Cisco Nexus 9000 Series switch?
The Cisco TACACS+ on a Cisco Nexus Series Switch must authenticate any user attempting to access the device and fail over to the local account if the TACACS+ server becomes unavailable. Which command accomplishes these goals?
Refer to the exhibit. An engineer must configure a QoS policy that controls only vHBA traffic. Which policy must be used to meet this requirement?
An engineer implements an Application Performance Monitoring (APM) solution. The solution runs in a vSphere infrastructure where the vSwitch support for promiscuous mode is disabled for security reasons. As a result, the final implementation must receive a copy of bidirectional traffic to a load balancer that is connected to a Cisco Nexus 93108 series switch. The APN solution GRE encapsulated traffic. Which configuration must be applied to the switch to meet this requirement?
Drag and drop the Cisco Nexus 9000 Series Switch software update processes from the left onto the corresponding characteristics on the right.
A customer data center experiences bandwidth contention that affects the servers connected to the NPV enabled switch The NPV switch is connected to the NPIV switch using two 10 Gb uplinks but the traffic originating front the connected hosts to the core switch exceeds the available bandwidth The engineers decided to add a third uplink to the NPV server to increase the available bandwidth Which set of commands must be used to provision the new uplink?
TESTED 31 Jul 2026
