A storage administrator notices an increasing number of storage targets that unexpectedly reach capacity, causing periodic service interruptions The administrator must now create and submit a daily report of the environment that shows the status of the storage targets with the highest capacities Which solution provides this information?
Refer to the exhibit. An engineer must add a new VRF to an existing VXLAN environment. The VRF and interface VLAN have already been configured. The deployment is configured with these parameters:
OSPF is used as the underlay.
BGP is used as the overlay.
The network virtual interface ID is 1.
The VXLAN network identifier must include the VLAN number.
Drag and drop the configuration snippets from the bottom to complete the VXLAN configuration.
Drag and drop the telemetry concepts from the left onto their functions on the right.
In a Cisco SAN fabric, UCS fabric interconnects and blades are all monitored by Cisco DCNM. The requirement is for the Cisco UCS manager to be monitored by Cisco DCNM. Which two
configuration steps accomplish this goal? (Choose two.)
An engineer needs a utility that translates traditional Cisco Nexus CLI commands and generates code using XML and JSON message formats. The utility must be available on a Cisco Nexus 7700 Series Switch. Which utility must be used?
Refer to the exhibit. An engineer configures a Cisco C-Series UCS server. The company policy states that all C-Series servers must be configured so that Cisco IMC is reachable only from the management port of the server. Which NIC configuration must the engineer apply to meet this objective?
An engineer must configure device aliases for a Cisco MDS 9000 Series switches-based SAN fabric. The configuration must meet these requirements:
• The engineer must be prompted before the changes are committed to the database.
• Pending changes must be explicitly displayed on the console.
Which command accomplishes this task?
A network engineer repeatedly saves a configuration on Catalyst switches to NVRAM using the write memory command. What action should be taken to implement the same action on Nexus switches?
An engineer must configure the RBAC role to perform these tasks In the Cisco UCS Manager:
Configure VLANs and VLAN groups.
Configure Ethernet Link Profile and LACP policy.
Specify the allowed range for virtual MAC addresses.
Configure SPAN Ethernet monitoring sessions.
Which set of permissions must be used to create a user role that accomplishes these roles?
Refer to the exhibit.
The server is sending traffic to the storage server using Fiber Channel protocol. The requirement is for the N5K-1 to forward traffic to MDS9k-1. Drag and drop the configuration steps from the right to complete the configuration for N5K-1 on the left. Not all configuration steps are used.
TESTED 31 Jul 2026
