Cisco Nexus 9000 Series Switches are configured with LACP protocol and default aging timers. What is the impact on the LACP peer during an ISSU upgrade?
Refer to the exhibit. Server 1-must establish an FCoE connection with SW1. Drag and drop the code snippets from the right onto the boxes in the code to complete the FCoE configuration of SW1. Not all code snippets are used.
An engineer must shut down the Ethernet 1/2 interface when the Ethernet 4/5 interface state is down. Drag and drop the CLI commands from the bottom onto the blanks in the exhibit to implement this EEM. Not all commands are used.
An engineer must implement Strict Unicast Reverse Path
Forwarding mode for IPv4 packets on the Ethernet1/1 interface on the Cisco Nexus 9500 Series Switch. Which configuration achieves this goal?
A)
B)
C)
D)
All logins to a Cisco Nexus 9000 Series Switch must pass through the TACACS+ server at IP address 192.168.10.10. The configuration must meet these requirements:
• The TACACS+ server must be used for SSH and Telnet.
• The TACACS+ server key must be Cisco123!.
• Management VRF must be used for connectivity.
• The deployment must fail back to local credentials if the TACACS+ server fails to respond within 30 seconds.
Drag and drop the code snippets from the right onto the blanks in the code on the left to complete the configuration. Not all code snippets are used.
A DevOps engineer must design a solution for a Cisco Unified Fabric solution to provision, monitor, and troubleshoot the network infrastructure for a data center based on Cisco Nexus
Series Switches. The solution must provide visibility and control of the unified data center. Which solution meets these requirements?
In a Cisco SAN fabric, UCS fabric interconnects and blades are all monitored by Cisco DCNM. The requirement is for the Cisco UCS manager to be monitored by Cisco DCNM. Which two
configuration steps accomplish this goal? (Choose two.)
Refer to the exhibit. An engineer implements an FCoE Unified Fabric where vPC exists between N9K-A and N9K-B. To avoid rate discards, bandwidth must be regulated to account for sent traffic that exceeds the access speed. Which set of commands completes the configuration?
A)
B)
C)
D)
Refer to the exhibit. An engineer must capture Fibre Channel traffic from the server and the supervisor to the Cisco MDS 9000 Series Switch fabric. The traffic must be forwarded to the analyzer Drag and drop the code snippets from the right onto the blanks in the code on the left to complete the configuration. Not all code snippets are used.
An engineer must authenticate OSPF on interfaces of me Cisco Nexus 9000 Senes Switch so mat
eth1/1 uses clear text password
etht'2 uses encrypted md5 password
Drag and drop the commands from the bottom onto the boxes in the code to complete me configuration Not all commands are used.
TESTED 29 Jan 2026
