A network engineer must configure the router R1 GigabitEthernet1/1 interface to connect to the router R2 GigabitEthernet1/1 interface. For the configuration to be applied the engineer must compress the address 2001:0db8:0000:0000:0500:000a:400F:583B. Which command must be issued on the interface?
Which unified access point mode continues to serve wireless clients after losing connectivity to the Cisco Wireless LAN Controller?
R1 has learned route 192.168.12.0/24 via IS-IS. OSPF, RIP. and Internal EIGRP Under normal operating conditions, which routing protocol is installed in the routing table?
Refer to the exhibit.
An administrator must configure interfaces Gi1/1 and Gi1/3 on switch SW11 PC-1 and PC-2 must be placed in the Data VLAN and Phone-1 must be placed in the Voice VLAN Which configuration meets these requirements?
When a WLAN with WPA2 PSK is configured in the Wireless LAN Controller GUI which format is supported?
Which result occurs when PortFast is enabled on an interface that is connected to another switch?