All logins to a Cisco Nexus 9000 Series Switch must pass through the TACACS+ server at IP address 192.168.10.10. The configuration must meet these requirements:
• The TACACS+ server must be used for SSH and Telnet.
• The TACACS+ server key must be Cisco123!.
• Management VRF must be used for connectivity.
• The deployment must fail back to local credentials if the TACACS+ server fails to respond within 30 seconds.
Drag and drop the code snippets from the right onto the blanks in the code on the left to complete the configuration. Not all code snippets are used.
A network administrator must create a daily scheduler job on a Cisco Nexus 9000 Senes Switch to back up the device configuration and transfer the backed-up configuration to an external server The backup task must meet these requirements
•The backup file must be saved in a directory named config_backup on the external server •The switch must send an email notification to the administrator when the job is complete
The scheduler job must be configured to run every day at 11 PM Which commands must be run on the switch?
A network engineer must configure a power redundancy policy on a Cisco UCS C-Series Rack Server. The power redundancy must support two power sources being used to power the server. Which configuration should be applied to meet the requirement?
A SAN administrator receives reports about latency and response-time issues that impact various applications. The incidents have gradually increased in frequency and seventy and have reached a critical state Which DCNM configuration set identifies the source of the issues?
Refer to the exhibit An engineer must build the VXLAN for a new customer
BGP is configured for Layer 3 connectivity and is confirmed to work as
expected The deployment must meet these entena:
•All VNI IDs must contain the VLAN that they represent
•Multicast must be used to transport ARP messages between the pods
Drag and drop the code snippets from the bottom onto the boxes in the code to complete the remaining Layer 2 connectivity.
Not all code snippets are used.
An engineer upgrades the bash on the Cisco Nexus 9000 Series Switch.
Which command must be used to complete the task?
Refer to the exhibit. An engineer monitors ingress traffic from Host-A and all traffic for VLAN 20 from Host-B Which configuration must be implemented to monitor and export traffic to Network Analyzer?
Refer to the exhibit. A network administrator experiences these issues with the network:
• PC1 is experiencing a buffering problem for video applications.
• The servers that are connected to SW2 are experiencing packet drops when they connect to the Internet.
The engineer wants to configure the required traffic capture to investigate the issue further. Which configuration must be implemented to monitor the traffic?
Refer to the exhibit An engineer must restrict users assigned to the sangroup role on the Cisco MDS 9000 Series Switch from issuing commands
on VSANs 15 to 20 Which command must the engineer run to achieve
this objective?
An engineer must configure Protocol Independent Multicast on two Cisco Nexus 9000 Series Switches. The engineer must ensure that the chosen rendezvous point (RP) uses a mapping agent and only supports one RP per multicast group. Which type of RP must be used on both switches to meet these requirements?
TESTED 31 Jul 2026
