5V0-22.23 VMware Exam Lab Questions

To restore the health of the vSAN cluster with minimum risk, the vSAN administrator must remove the devices from the storage pool, replace the storage devices, and claim the new devices in vSAN. This is because removing and replacing devices in a storage pool does not affect the availability or performance of the objects stored in that pool. The storage pool automatically rebalances the objects across the remaining devices in the pool when a device is removed, and distributes the objects across the new devices when they are added. This process is faster and safer than removing and re-adding a host to the cluster, which requires resynchronization of all objects on that host4 References: 4: VMware vSphere Storage Guide, page 133 : VMware vSAN Design and Sizing Guide, page 38

The two prerequisites for using the TRIM and UNMAP capability of vSAN are:

• B. The vSAN cluster is an all-flash architecture. TRIM and UNMAP are only supported on all-flash vSAN clusters, as they can reclaim space from flash devices that use thin provisioning. TRIM and UNMAP are not supported on hybrid vSAN clusters, as they cannot reclaim space from magnetic disks that use thick provisioning1.
• D. TRIM and UNMAP is enabled. TRIM and UNMAP are disabled by default in vSAN, as they might have a performance impact on some workloads. To enable TRIM and UNMAP on a vSAN cluster, the administrator must use the following RVC command: vsan.unmap_support –enable2. After enabling TRIM and UNMAP, the administrator must power off and then power on all VMs that use the vSAN datastore.

To allocate additional storage from another vSAN enabled vSphere cluster to this vSAN enabled Cluster, the administrator should use the vSAN HCI Mesh feature. This feature allows a vSAN cluster to consume storage resources from another vSAN cluster without requiring the hosts to be part of the same cluster. This way, the administrator can leverage the unused or underutilized storage capacity from another cluster and avoid purchasing new hardware or migrating VMs. The vSAN HCI Mesh feature also supports storage policies, encryption, deduplication and compression, and erasure coding across clusters12 References: 1: VMware vSAN Specialist v2 Exam Preparation Guide, page 15 2: VMware vSAN 7 Update 1 - HCI Mesh 3

Utilizing Network I/O Control and isolating vSAN traffic in a VLAN are the two actions that should be taken to configure the new vSAN cluster to meet the requirements. Network I/O Control allows the vSAN administrator to create network resource poolsand assign bandwidth shares or reservations to different traffic types, such as vSAN, vMotion, or management. This ensures that vSAN traffic has guaranteed bandwidth during contention and can achieve better performance and availability. Isolating vSAN traffic in a VLAN enhances the security of the cluster by preventing unauthorized access or interference from other network segments. It also simplifies the network configuration and management by reducing the broadcast domain and avoiding IP address conflicts. Creating static routes between the vSAN hosts, using IOPS Limit rules in storage policies, and enabling jumbo frames are not necessary or recommended actions for this scenario. Static routes are not required for vSAN communication, as vSAN uses multicast or unicast depending on the version and configuration. IOPS Limit rules are used to limit the IOPS allocated to an object, which can degrade the performance and latency of the application. Jumbo frames can improve the network efficiency and throughput, but they are not mandatory for vSAN and require consistent configuration across all network devices. References:

• Network I/O Control
• vSAN Network Design Guide