CWNA-109 VCE Exam Download

An IBSS is used instead of a BSS is a network configuration that would result in multiple stations broadcasting Beacon frames with the same BSSID but with different source addresses. An IBSS (Independent Basic Service Set) is a type of WLAN that does not use an AP but rather allows stations to communicate directly with each other in a peer-to-peer manner. An IBSS is also known as an ad-hoc network or a peer-to-peer network. In an IBSS, each station generates its own Beacon frames to announce its presence and capabilities to other stations within range. The Beacon frames have the same BSSID, which is randomly generated by one of the stations when creating the IBSS, but they have different source addresses, which are the MAC addresses of each station’s radio interface. The BSSID is used to identify the IBSS and prevent stations from joining other IBSSs with different BSSIDs. References: , Chapter 1, page 25; , Section 1.1

PoE stands for Power over Ethernet, which is a technology that allows network devices to receive power and data over the same Ethernet cable. PoE eliminates the need for separate power adapters or outlets for devices such as IP phones, cameras, or APs. PoE requires two types of devices: PSE (Power Sourcing Equipment) and PD (Powered Device). A PSE is a device that provides power to the Ethernet cable, such as a switch, injector, or splitter. A PD is a device that receives power from the Ethernet cable, such as an IP phone, camera, or AP. When implementing PoE, a switch plays the role of a PSE910. References: CWNA-109 Study Guide, Chapter 7: Power over Ethernet (PoE), page 293; CWNA-109Study Guide, Chapter 7: Power over Ethernet (PoE), page 287.

VHT stands for Very High Throughput, which is a physical layer (PHY) specification that supports the 5 GHz frequency band and supports 80 MHz channels. VHT is used by the IEEE 802.11ac standard, which is also known as Wi-Fi 5. VHT allows for higher data rates and more spatial streams than the previous HT (High Throughput) PHY, which is used by the IEEE 802.11n standard, also known as Wi-Fi 4. HT supports the 2.4 GHz and 5 GHz bands, but only supports up to 40 MHz channels12

The other options are not correct because:

• ERP (option C) stands for Extended Rate PHY, which is a physical layer specification that supports the 2.4 GHz frequency band and supports up to 20 MHz channels. ERP is used by the IEEE 802.11g standard, which is also known as Wi-Fi 3. ERP allows for higher data rates than the previous DSSS (Direct Sequence Spread Spectrum) PHY, which is used by the IEEE 802.11b standard, also known as Wi-Fi 234
• OFDM (option D) stands for Orthogonal Frequency Division Multiplexing, which is a modulation technique that divides a signal into multiple subcarriers that are spaced orthogonally to each other. OFDM is not a physical layer specification, but a common feature of many PHY specifications, including ERP, HT, and VHT. OFDM allows for higher spectral efficiency and robustness against multipath interference than the previous CCK (Complementary Code Keying) modulation technique used by DSSS34

The BSSID (Basic Service Set Identifier) is typically mapped to an AP’s MAC address if a single BSS is implemented. The BSSID is a unique identifier that distinguishes one BSS from another within the same RF medium. It is usually derived from the MAC address of the AP’s radio interface, but it can also be manually configured or randomly generated by some vendors. The BSSID is used by client stations to associate with an AP and to send and receive frames within a BSS. References: , Chapter 1, page 24; , Section 1.2