CWNP Certification CWAP-404 Passing Score

Display filters are applied after the capture is completed and they only hide the packets from view. The filtered packets are still present in the capture file and can be enabled for view later by changing or removing the display filter. This is an advantage over capture-time filters, which discard the packets that do not match the filter criteria and cannot be recovered later34 References:

• CWAP-403 Study Guide, Chapter 2: Protocol Analysis, page 37
• CWAP-403 Objectives, Section 2.3: Apply display filters

The device finder is a common feature of a spectrum analyzer that helps locate a non-802.11 interference source. The device finder uses a directional antenna to measure the signal strength of a specific frequency or signal source. By pointing the antenna in different directions, the device finder can indicate the direction and distance of the interference source. The device finder can also filter out other signals that are not related to the interference source. The other options are not correct, as they do not help locate a non-802.11 interference source. Max hold and min hold are features that show the maximum and minimum RF power levels over time,respectively. Location filter is a feature that filters out signals that are not from a specific location or area. References: [Wireless Analysis Professional Study Guide CWAP-404], Chapter 3: Spectrum Analysis, page 77-78

When a data frame is encrypted with WPA2, the encryption is applied to the frame body including the LLCPDU. The LLCPDU (Logical Link Control Protocol Data Unit) is a part of the frame body that contains information such as protocol type, source and destination service access points (SAPs), and control fields. The LLCPDU is added by the LLC (Logical Link Control) sublayer to provide multiplexing and flow control functions for different upper layer protocols. When a data frame is encrypted with WPA2, which uses AES-CCMP as its encryption algorithm, both the payload and the LLCPDU are encrypted as a single unit. The MAC header and FCS are not encrypted, as they are needed for addressing and error detection purposes. References: [Wireless Analysis Professional Study Guide CWAP-404], Chapter 5: 802.11 MAC Sublayer, page 115-116

The function of the PHY layer is to convert PSDUs to PPDUs for transmissions and PPDUs to PSDUs for receptions. A PSDU (PHY Service Data Unit) is the data unit that is passed from the MAC layer to the PHY layer for transmission, or from the PHY layer to the MAC layer for reception. A PPDU (PHY Protocol Data Unit) is the data unit that is transmitted or received over the wireless medium by the PHY layer. A PPDU consists of a PSDU and a PHY header, which contains information such as modulation, coding, and data rate. The PHY layer adds or removes the PHY header to or from the PSDU during the conversion process. References: [Wireless Analysis Professional Study Guide CWAP-404], Chapter 4: 802.11 Physical Layer, page 97-98