Netapp NS0-520 Actual Questions

Page: 3 / 8

Question 12

You want to access and mount a Linux L.UN using only iSCSl. In the past, the LUN ha;; been accessed using FC. What must you do to accomplish this task?

Options:

Change the LUN protocol type to (SCSI.

Create a new iSCSI igroup. and change the LUN mapping from the original to the new igroup.

Create a new iSCSI Igroup and map the LUN to both the new and existing FC igroup.

Add an iSCSI protocol type to the existing igroup so that the LUN can be accessed by both FC and iSCSI hosts.

Question 13

A customer recently added two nodes with FC ports to a 4-node cluster.

Which SVM configuration is needed before the customer creates LUNs on the new nodes?

Options:

The FC service needs to be enabled on the data SVM.

The existing LIFs need to be migrated to the new nodes.

New FC LIFs need to be created on the cluster SVM.

New FC LIFs need to be created on the new nodes.

Question 14

You are configuring both NVMe and FC on the same AFF A800 2-node ONTAP 9.5 cluster. You are configuring both protocols on the same Cisco FC network switches.

In this scenario, which configuration on the cluster is supported?

Options:

a volume with both LUNs and namespaces

an SVM with both nvme and fcp allowed protocols

an AFF A800 node HBA with both NVMe/FC and FC on the same port

a LIF with both fc-nvme and fcp data protocols

Question 15

A customer has an AFF A700 connected to a Cisco switch and has verified connectivity but cannot see any LUNs. The customer issued the run -node scaling-01 -command fcp topology show command to verify the connection.

Referring to the exhibit, what needs to be enabled on the Cisco switch?