Pass Using 156-315.81 Exam Dumps

The SmartEvent component that creates events is the Correlation Unit, which is responsible for correlating and analyzing security events to identify patterns and potential threats.

Option A, "Consolidation Policy," does not create events but is used to configure policies for event consolidation.

Option C, "SmartEvent Policy," is not responsible for creating events but is used to configure policies related to SmartEvent.

Option D, "SmartEvent GUI," is the graphical user interface for managing SmartEvent but does not create events itself.

References: Check Point Certified Security Expert (CCSE) R81 documentation and learning resources.

The cphaconf set_ccp multicast command is used to set the Cluster Control Protocol (CCP) to Multicast mode. This mode allows cluster members to communicate with each other using multicast packets. The other commands are either incorrect or set the CCP to Broadcast mode. References: ClusterXL Administration Guide

 The cphaprob -a if command displays the interface status of all cluster members, including the interface name, IP address, state, monitor mode, and sync status. References: cphaprob - Check Point Support Center

 When doing a Stand-Alone Installation, you would install the Security Management Server with the Security Gateway as the other Check Point architecture component. A Stand-Alone Installation is where the Security Management Server and the Security Gateway are installed on the same machine2. The other options are either not Check Point architecture components, or not suitable for a Stand-Alone Installation. References: Check Point R81 Installation and Upgrade Guide